Barrow Logo Barrow EP Handbook

Auto repair shop with lifts, floor drains and a separator

The subject property is, or was, an auto repair shop with in-ground hydraulic lifts, floor drains and an oil-water separator. The standard does not classify any of these features. Whether one makes a recognized environmental condition (REC) depends on four things: what the shop used and for how long, where the drains and the separator discharge, what the below-grade equipment held and whether it leaked, and what evidence of a release exists.

What the answer turns on

Each fact bears on whether a release from the shop is known or likely (E1527-21, 3.2.73).

  • What the shop used, and for how long. The environmental professional considers what releases past uses could have led to (E1527-21, 8.3.1). The standard's appendixes are nonmandatory. For a likely release, the one on the REC definition points to operations involving hazardous substances or petroleum products, how long they ran and when, including periods when management practices or regulatory oversight may have been lacking (E1527-21, X4.1). Establish the oils, fuels and solvents used and the years of operation. Migration includes vapor in the subsurface (E1527-21, 3.2.53): see vapor in a Phase I.
  • Where the drains and the separator discharge. Drains and sumps, wastewater discharged from the subject property, septic systems, and wells including dry wells and injection wells are site visit features (E1527-21, 9.4.21, 9.4.26, 9.4.27, 9.4.28). Establish whether each drain and the separator lead to a public sewer, a septic system, a dry well or the ground. The federal injection well rule (40 CFR part 144) counts a septic system and a drywell as wells (40 CFR 144.3). Under it a well that receives or has received fluids from vehicle repair or maintenance is a motor vehicle waste disposal well: new ones are prohibited as of April 5, 2000, and an existing one "in a ground water protection area or other sensitive ground water area", or anywhere in a State where the State or EPA Region has not identified those areas, must be closed or permitted (40 CFR 144.81(16), 144.84(b)(2), 144.85(b)).
  • What the below-grade equipment held, and whether it leaked. Hydraulic equipment known or likely to contain polychlorinated biphenyls (PCBs) is a site visit feature (E1527-21, 9.4.18). The site visit need not identify conditions under floors (E1527-21, 9.2.4.2), so this fact leans on records and interviews: when the lifts and the separator were installed, what fluid they held, whether they were removed or left in place, and whether a removal was documented. The standard does not say whether a separator or a lift reservoir is an underground storage tank as it defines one (E1527-21, 3.2.93). The federal tank rule (40 CFR part 280) excludes hydraulic lift tanks, as quoted below. It does not name separators; it excludes a "wastewater treatment tank system that is part of a wastewater treatment facility regulated under Section 402 or 307(b) of the Clean Water Act", and for other wastewater treatment tank systems seven subparts, closure among them, do not apply, while the one on release response and corrective action does (40 CFR 280.10(b)(2), (c)(1)). Ohio's tank bureau says some oil and water separators are exempt from its closure rule while a release from one is still regulated under its corrective action rule (Ohio).
  • Evidence of a release. Odors, stains on floors, stained soil or pavement, and sumps whose liquids are likely hazardous substances or petroleum products are site visit features (E1527-21, 9.4.13, 9.4.14, 9.4.20, 9.4.23). The practice includes no sampling (E1527-21, 7.4). A release that is found is weighed against the de minimis definition (E1527-21, 3.2.20): see staining on pavement or soil.

The records that bear on it

  • Historical sources. Street directories and fire insurance maps can identify a repair use and its years (E1527-21, 8.3.4.2, 8.3.4.3).
  • Government records. A shop may be listed as a hazardous waste generator (RCRA generators) or hold registered storage tanks; the required minimum search for both covers the subject property and adjoining properties (E1527-21, 8.2.2, Table 2). Neither listing records a release.
  • Site visit. The interior is observed, including maintenance and repair areas (E1527-21, 9.2.3). Each listed feature is described in the report or reported as not found (E1527-21, 9.4).
  • Interviews and documents. Interview questions shall try to cover the same features, current and past (E1527-21, 10.2): ask where the drains lead, how the separator was serviced and what became of old lifts. Before the site visit the owner, key site manager and user are asked for wastewater and underground injection permits, generator notices and tank registrations (E1527-21, 10.8.1).

What the federal rule says

Among what the inquiry rule (40 CFR part 312) says the inquiry must seek to identify:

Current and past uses of hazardous substances;

40 CFR 312.20(e)(1)(ii), edition revised as of July 1, 2025

For a party seeking the liability protections that item stops at hazardous substances; the standard includes petroleum products (E1527-21, 1.1.2).

The federal injection well rule, on what goes into motor vehicle waste disposal wells:

These fluids also may include waste petroleum products and may contain contaminants, such as heavy metals and volatile organic compounds, which pose risks to human health.

40 CFR 144.81(16), edition revised as of July 1, 2025

The federal tank rule excludes:

Equipment or machinery that contains regulated substances for operational purposes such as hydraulic lift tanks and electrical equipment tanks.

40 CFR 280.10(b)(3), edition revised as of July 1, 2025

How it is written up

The repair use is described with the other identified uses (E1527-21, 8.3.8). A feature is a finding when the professional judges it may indicate hazardous substances or petroleum products present or likely present at the subject property (E1527-21, 12.5).

Where the professional concludes a release is known or likely and presence at the subject property follows, the opinion names the feature and the grounds: the materials, the years, the discharge point, the evidence. Unless judged a de minimis condition or a historical REC, the REC is listed in the Conclusions, and the professional should give an opinion on additional investigation, if any (E1527-21, 3.2.20, 3.2.39, 12.6, 12.7, 12.8).

Where the professional concludes otherwise, the opinion on a finding gives its reasoning on the same four facts (E1527-21, 12.6).

The standard's own example of a significant data gap is a building that could not be entered whose use, in the professional's experience, often leads to a REC (E1527-21, 12.5.1). Access to a locked service bay, or an interview with the key site manager, may be what cannot be had. Required information that good faith efforts could not obtain is a data gap, significant if it affects the ability to identify a REC: named in the Findings with the sources consulted, discussed in the Opinions and listed in the Conclusions (E1527-21, 3.2.19, 3.2.78, 12.5.1, 12.6.2, 12.7).

Related

This page is general reference for environmental professionals. It does not classify any property. ASTM E1527-21 is the standard and is not reproduced here; the judgment of the environmental professional on the facts governs.

Maintained by Barrow. General reference only, not legal or professional advice. Barrow is not affiliated with any government agency, and neither Barrow nor the information as presented here is endorsed by any state or government agency. See how Barrow drafts the report